Nice job. Kitchens are a big job.

Miamicuse wrote:I have the daredevil spade bits. I use them occasionally for rough holes. It’s handy since its impact ready so you can use a driver for it. I used it last week to make a 1″ hole through a 3″ diameter tree root.

Have you had your wrists snapped yet when the bit breaks thru the wood ?
I use them a lot when running wire. I have…[Read more]

Pretty sweet. Our Harbor Freight one is junk.

We have torn out quite a few of them.

Good luck Dirty, I got a tablet a couple years ago and never did figure it out. It collects dust.

RonW wrote:All the molding hs been cut and put on. Now the fun begins. All the Hand Sanding.

Well Ron , my wife saw the picture and she wants one.
It is beautiful !

Wasn’t really a black Friday sale but was at the big Hartville Hardware today and they were having their big tool sale. All the reps were there .
The place was a madhouse! I barely found a parking place.

smallerstick wrote:

roninohio wrote:
My boss’s wife asked me to make 15 of these wood tree things for her church. The kicker is that they have to come apart for storage.
I am going to try using small chain at the bottom instead of wood. I am going to try and use 3 eye screws where the 3 tops come together. I am not sure how to figure out the a…

[Read more]

My boss’s wife asked me to make 15 of these wood tree things for her church. The kicker is that they have to come apart for storage.
I am going to try using small chain at the bottom instead of wood. I am going to try and use 3 eye screws where the 3 tops come together. I am not sure how to figure out the angles where the tops come together. The…[Read more]

RonW wrote:

DirtyWhiteBoy wrote:
Yesterday I saw at HD a bosch paddle bit set for 5.99$ there were 8 or 9 bits in it.

I picked a set last week. It’s a good buy.

I got the Daredevil set for $4.99 at HD Wednesday.

I haven’t had any luck with stud finders on plaster either. Just happened yesterday trying to find studs for closet shelves. Had to use the hammer thump method and lots of liquid nail.

Oh, Congrats on your box Doobie !

I have seen that on FB a lot. I was tempted but didn’t try it.
I have seen pretty much the same add under a lot of different names.
Usually if it seems to good to be true ……….

Might check this out

https://www.trustpilot.com/review/vipnom.com

RonW wrote:I’m working on a small entertainment center. Lots of molding to put on this one.

That is coming along nice Ron. Still admiring that nice clean shop!
Looks like a lot of doors made already.

I installed butcher block countertops yesterday. I thought it would be a good test for my Bosch CCS180B and JSH180B . I had to cut a miter through the 1 3/4″ thick maple . The circular saw cut it like butter and a very smooth cut. The 18v jig saw buzzed right through cutting the sink hole.
I have a day or so at this house and then I move on to…[Read more]

Miamicuse wrote:well well well I got a box from Bosch today.

It’s the GLM20 laser measure and the GMS120 wall scanner.

Thank you Bosch and Brittany!

Awesome ! Glad to see the boxes flowing again.

Welcome to BTP Nate. Don’t be shy!

Ha ha @Doobie you had fun with that one.

I always find honest is always best. If you don’t like the person say so.
If it is a job you can’t do say so.
My neighbor that I liked very well was always having something done on his house. He found fault with every single job. He always got them to give money back. He sued his friend for concrete…[Read more]

TopNotch wrote:Yes Ron it’s concrete an inch-and-a-half thick it’s a beast.

the chipper is not even breaking it up it pops the tile off and that’s it. I have some kind of wired membrane for laughs and then your typical wire lath for inside corners and transitions because there is so many transitions and studs in a small room there are tons of na…

[Read more]

Had about a 1/2″ of snow on the ground this morning in Ohio. I despise winter ! yukkk

@TopNotch The cabinets you are taking out look really nice. I hope they go to a new home. That bathroom does look like a monster! Is that concrete behind the tile? It is a bear to remove.

@Boschmanbrian Hope your doing better. I came home early today myself. Just not feeling good either.