dcsimg

General Metal cutting saw discussion

Viewing 2 posts - 61 through 62 (of 62 total)
  • Author
    Posts
  • #534079
    crotalusco
    Pro
    west bend, wi

    in truth i will not use the new saw for 20ga much. The bosch cordless is just too perfect for that. So ill save the big corded one for structural jobs

    #551005
    gomoto69
    Pro
    salmon arm, bc

    I’ve used a non ferrous metal cutting blade on my makita circular saw to cut lots of aluminum plate .100″ to 1/4″, cuts very well, but very loud and lots of hot chips. Full face shield, ear muffs and long sleeves highly recomende, but cuts very well. Chios under the saw plate tends to scratch up the surface tho, so protect it if looks are important. I’ve used the same blade on my chop saw to cut aluminum tubing and bar stock as well, i think for non ferrous metal the rpm isn’t as much of a factor, i wouldn’t try the steel cutting blades at such high rpm.

Viewing 2 posts - 61 through 62 (of 62 total)
  • You must be logged in to reply to this topic.
© Robert Bosch Tool Corporation 2014, all rights reserved.
queries. 0.212 seconds