BTP Review: Bosch Impact Tough Drilling and Driving Bits

Viewing 61 post (of 61 total)
  • Author
  • #656610

    At times I found the little one inch bits sometimes don’t stay in the magnetic holder, that’s why I like the two or even three inch bits that go directly into the impact and no holder

    Magnetic holders that have a retaining ring built in to engage the detents on the corners of the bits are my favourites but they are so hard to find. They are most common in industrial components which usually carry a pretty hefty price, too.

    Actually I have one in my dewalt impact bit set, it’s good, really holds the bits in, so good I need pliers to get those little one inch bits out

Viewing 61 post (of 61 total)
  • You must be logged in to reply to this topic.
© Robert Bosch Tool Corporation 2014, all rights reserved.
queries. 0.276 seconds